RFTC-10/G_complet(cover – white, frame – white)

• The simple controller in design LOGUS90 measures the room temperature by internal sensor, and based on the set temperature, it sends a command to control heating.
• The temperature controller can be used in one of two ways:
  • For controlling an additional heat source (heater, oil radiator, radiant panel) with multi-function switching units RFSA-6x, RFUS-61 or RFSC-61.
  • For suffi cient temperature correction (± 5 °C) over the course of the program set in the system unit change in temperature applies until the following set change of the heating program in the system unit).
• Manual control by buttons on the unit.
• Range of measured temperature 0-55 °C.
• The backlit LCD display displays the current and set temperature, status (ON/OFF), battery status, etc.
• Battery power (1.5 V / 2x AAA – included in supply) with battery life of around 1 year based on frequency of use.
• The flat rear side of the device enables its placement anywhere in the room where you wish to measure temperature.
• Range up to 100 m (in open space), if the signal is insuffi cient between the controller and unit, use the signal repeater RFRP-20 or protocol component RFIO2 that support this feature.
• Communication frequency with bidirectional protocol iNELS RF Control.
• Color combination of heating unit in design of frames LOGUS90 (plastic, glass, wood, metal, stone).

Technical parameters 

• Supply voltage: 2 x 1.5 V AAA battery
• Battery life: 1 year
• Display: LCD, characters / see Display description
• Transmission indication / function: symbols
• Transmitter frequency: 866 MHz, 868 MHz, 916 MHz
• Range in free space: up to 100 m
• Operating temperature: 0 to +55 °C
• Protection: IP30
• Weight: 66 g (without batteries)