WSCL-24-BS Wireless shutter control – luxury

Wireless shutter control – classic

Combination of iNELS wall-mounted wireless controller and shutter switching device.

RFGB-40/B

• The wireless control – is used to control, lights, gates, garage doors, shutters, etc.
• The thickness is only 8 mm.
• 4 capacitive buttons allow you to control 4 components.
• Fast installation on any surface – the rear base allows screwing to the walls, gluing with double-sided tape, or just laying on the table

RFJA-32B-SL

• The switching unit for blinds has 2 output channels used to control garage doors, gates, blinds, awnings, etc…
• It can be combined with system components iNELS RF Control2 with RFIO2 protocol.
• The BOX design lets you mount it right in an installation box, a ceiling, or a motor drive cover.
• Short presses of the controller enable tilting of lamellas, and a long press enables you to draw the blinds up or down to the end position.
• Each of the units may be controlled by up to 25 channels (1 channel represents one assigned controller).
• The programming button on the unit is also used for manual control of the output.
• For components, it is possible to set the repeater function via the RFAF / USB service device.
• Range up to 200 m (in open space), if the signal is insufficient between the controller and unit, use the
• Signal repeater RFRP-20 or protocol component RFIO2 support this feature.
• Communication frequency with bidirectional protocol iNELS RF Control2 (RFIO2).